Starlink Masonry Routing Kit: Brick, Block and Concrete Walls
Masonry walls need a different approach from wood frame — different drilling, different fixings and different sealing — and Starlink offers a routing kit intended for those situations.
The practical difference is that masonry is unforgiving. A wood-frame penetration in the wrong place can be patched almost invisibly. A hole in brick or concrete is permanent, and repositioning it is not a small job. That raises the value of getting the route right the first time.
- DIY difficulty
- Best done professionally
- Drilling required
- Yes, through masonry — which needs the right tooling and confidence about what is behind the wall.
What it is best for
- Brick, block and concrete exterior walls
- Older Alberta homes with solid masonry construction
- Commercial buildings with concrete or block envelopes
Limitations worth knowing
- Requires a hammer drill and appropriate masonry bits
- Mistakes are permanent and difficult to make good
- Dust and debris management matters inside a finished room
- Structural elements and embedded services must be identified first
In Alberta conditions
Masonry and freeze-thaw are a poor combination when a penetration is sealed badly. Water that gets into a poorly sealed hole in brick will freeze, expand and progressively damage the surrounding material over a few winters. Sealing a masonry entry properly, with a cold-flexible exterior product and a drip loop, matters more here than in a milder climate.
Where to get it
We do not sell this hardware and make nothing on it. Buy it directly from Starlink, and confirm current compatibility with your dish generation on their site — specifications change, and this page is not the authority on them.